answersLogoWhite

0

How do you change stater on 95 blazer?

Updated: 10/20/2022
User Avatar

Wiki User

15y ago

Best Answer

disconnect battery, get under blazer on passenger side behind passenger side front wheel. look beside the oil pan in front of the transmission bell housing. the starter will be right there and you should be able to see the flywheel, it is big and thick and round with gear teeth on it. on the bottom side beside the oil pan you should see the starter which is bolted to the engine block. take the electrical wires off the starter solenoid one at a time and be sure to mark them somehow so you will remember where they go when you put the new starter on. there should be 2-3 bolts holding the starter on. the bolt heads will be on the bottom side going up into the block holding it on. loosen the bolts but don't take them completely out. when you get them all loose enought to where you can turn them with your hand, hold the starter and unscrew them the rest of the way out. before you completely remove the starter, check the area between the starter and the engine block to see if there are any shims in place. if there are shims in place, most likely they will need to go back on with the new starter. otherwise when you try to crank the engine, the starter will make a terrible noise. installing the new starter can be done with this same process, just in reverse order. REMEMBER, mark the wires so you can put them back in the right place. when you handle the wires, be careful not to pull a connection loose from another place, and handle the wires with care. some vehicles have what is called a fusible link coming off the starter. it is basically a fuse in the form of a wire. you can disrupt this fusible link by improper handling. also before resuming operation, make sure that there are no starter wires touching metal anywhere other than the connector. otherwise you could eventually rub a wire's insulation off causing a ground. then your battery will never stay charged due to the wire being grounded out, and it will probably be almost impossible to find later. happy wrench turning.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change stater on 95 blazer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a transmission out of a blazer fit into a 95 S10 pickup?

if it's out of a 95 blazer it will work


What is cost for strut replacement for a 95 blazer?

95 s10 blazer doesn't have struts


Will a 95 Chevy Blazer grill and headlights fit on a 96 Chevy Blazer?

Fit 96 grill in 95 blazer


95 Chevy Blazer?

answer what? there is no question


Will a 1994 blazer transmission fit a 95 blazer?

Yes they are the exact same.


Why would a 1996 Chevrolet Blazer lose power at 95 mph?

Change the fuel filter or it may be the rev limitor that is in the computer..


How do you change the rearend fluid in a 95 Chevy blazer?

You have to remove the diff cover, then replace with new gasket and refill thru plug.


Will a 96 blazer transmission fit a 95 blazer?

Possibly, but you haven't said which engine or trans.


Where is the crank position sensor for a 95 blazer?

Where is the crank position sensor hole on a 2003 Blazer


Where is the ecm located in 95 S10 blazer?

The ECM unit for a 95 S-10 Blazer is located under the hood on pass. side.. Right in the open.


How often do you change plugs on 95 blazer?

Standard spark plugs, 50000 miles. Platinum tip spark plugs, 100000 miles.


Is there a reset switch for the ignition system for a 95 blazer?

No there is not.