To access the driver's side tail light, open the tailgate. There are two torque head screws that hold the bulb housing in place. These screws can be removed by reaching a regular length torque screw driver through the hinge area. After the screws are removed, simply pry the housing loose. The bulbs are removed by turning the bulb sockets 90* left and then pull out.
I have replaced only the driver's side light housing, so I'm not sure how to access the passenger side light housing. It should be similar.
what is this code p1491 on 2003 jeep liberty
A 2003 Liberty does not have a cabin filter.
The dome light fuse on a 2003 Jeep Liberty can be changed by first locating the fuse panel near the hood release. The dome light fuse can then be pulled from its socket and a new fuse put in place.
See the amswer for "How do you change the rear stop light bulb on a 2002 Jeep Liberty passenger side". It works.
WHAT?Have your wife or girlfriend or mom do it for you girlyman
Have vehicle scanned to determine the problem
replace rear tail light bulb
Service required is the oil change reminder. Service engine soon would be the check engine light.
Remove transmission oil pan
the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine
No. A 2003 Jeep does not have a cabin filter.
Yes , the V6 in a 2003 Jeep Liberty is a 3.7 liter
It does not have a mass air flow sensor.
How do you reset engine light on jeep liberty diesel
A 2003 Jeep Liberty uses red, hoat, five year coolant.
2005 jeep liberty 4wd 3.7l how to change diff.oil
You have to remove the transmission oil pan to access the filter.
The 3.7 litre V6 engine in a 2003 Jeep Liberty has a timing CHAIN
As 2003 Jeep Liberty uses 5W30 engine oil. It can be synthetic, conventional, or a blend.
According to my 2003 manual, the light comes on with approx 2.7 US Gallons (10L).
The fuel pressure of a 2003 Jeep Liberty Sport depends on the usage of the car. It can also depend on the elevation.
Try the owners manual. They usually include procedures for routine maintenance such as this.
I have a 2003 Jeep Liberty, jack is under the rear seat on passenger side.