tail lamp comes in 2 piecs 1 is the light board the other is the lens complete there is no cover 2 replace lens u need to remove center trunk cover where trunk latch is its held down with plastic press clips then u peal cloth panel aside on what side ur replacing and there are about 5 or 6 8,mm bolts remove bolts and push lens from the inside out dont 4 get 2 change the seal or u will get a water leak
look in the owners manual very helpful book. or remove plastic cover and twist plastic cover where build is
There is a plastic cover in the front wheelwell that gives access to the headlamps
no se como cambiarlo
The plastic cover will pop off. Then remove bulb.
you could have anything from a fuse to a blower motor problem ,,the blower moter is under the wiper assembly ,,, remove the assembly by removeing the 10 mill bolts ,,, and the plastic cover on the blowermotor houseing is held on with clips ,,, also check the blower resistor module which is in the blower housing
Yeah...the cardboard cover was made of cardboard and the plastic one was err.....plastic?
We have detailed headlight change procedures at our enthusiasts forum www.trailvoy.com
LG does manufacture a hard plastic cover for the LG Xenon. Aside from hard plastic cover, LG also offers a soft silicon cover, a paper cover and a titanium cover.
about front of rear right wheel. take out plastic cover.
take off plastic cover plugs and coil packs r located there
behind rear wheel passenger side. take out plastic cover.
remove left front plastic (driverside) wheelwell cover