In the firewall. Between the engine compartment and the passenger compartment
no , the heater core is for your heat , the evaporator core is for your air conditioning ( cooling )
In order to change the evaporator in Pt Cruiser, the entire dash has to be removed, then replace the evaporator, and reinstall the complete dash.
no! sensor is the one senses the cooling of the air condition while the evaporator core is the lid of the sensor
On the passenger side fire wall under the hood by the evaporator core. Goes into the fire wall.
A leaky schrader valve cannot corrode evaporator core. You're probably getting corrosion on the outside of evaporator from debris when the blower blows on it
Yes, both the heater core and evaporator are in the HVAC housing, which has to be removed to access either.
First, you get a manual and then follow the step by step instructions. This is how you install a evaporator core. No thank you is required. I like to help.
Before you remove the evaporator core from a 1998 Pontiac Bonneville you need to have the air pressure discharged. You will then need to remove the AC unit. You will need to remove some screws before you can remove the evaporator.
Yes, that would be a good idea given the age of the truck.
The evaporator on the Ford Mustang is located between the dash and the firewall. Dash removal is required to remove the evaporator for replacement. The dealer replacement evaporator comes with the evaporator housing. The intake air assembly, blower motor, blower resistor, actuators, heater core, etc., have to be switched to the replacement housing. There is a photo on Honda Man's Bio page with the dash removed and the evaporator housing placed on the rear of the car.
how do you change a heater core on a 2003 ss Monte Carlo
I am not exactly sure of what you are asking but there is not an evaporator valve. There is an evaporator core that resembles a radiator and there are not any parts that can stick. The only problem they have is leaking. There is an orfice that goes in the inlet to the evaporator and it has no moving parts.It can get stopped up and cause the high side pressure to get higher than normal.