no , the heater core is for your heat , the evaporator core is for your air
conditioning ( cooling )
Heater core is on the passenger side behind the glove box, this is also the location of the air conditioner evaporator core.. they should be in the same housing.
The heater core is behind the AC evaporator core. You must remove the panel with the venting on the passenger side. Then you must disconnect the two AC fittings inside the engine firewall. You do not have to remove the AC evaporator core, it will swing somewhat out of the way so that you can get to the heater core. There are several clips and screws holding the heater core in place that must be removed. Then you are able to remove the heater core. It is about a $35.00 item.
The heater core and AC system aren't connected.. the only component of the AC system located near the heater core is the evaporator.. so long as you don't try, say, prying out the heater core carelessly, there's nothing it should do to the AC system.
no! sensor is the one senses the cooling of the air condition while the evaporator core is the lid of the sensor
You will have to disconnect the liquid line and the accumulator from the evaporator tubes in order to remove the heater core.....
Yes, both the heater core and evaporator are in the HVAC housing, which has to be removed to access either.
Behind / below the glove compartment , inside the plastic box with the heater core
The entire, and I mean ENTIRE front dash has to come out to remove the heater box which then must be disassembled in order to replace the evaporator or heater core. Not a job for the feint of heart.
drain coolant. remove heater hoseson the inlet and outlets inside engine compartment passenger side near firewall.remove heater core pipe clamp.remove the glove box.remove insulation below it.remove the evaporator temp sensor wiring clip from the heater core cover. remove heater core cover. remove core clamp then slide the core out carefully.
In the same manner as replacing the heater core. The complete dash assembly must be removed. Big job.
On a 1998 Ford Ranger : The evaporator core for the air conditioning system is inside the plastic case ( that also holds the heater core ) located behind and below the glove compartment in the dash on the passenger side
the heater core is located behind the instrument panel, you have to remove it and place it on the seat. there are 2 covers that you have to remove before you see the heater core. remove the evaporator case assembly and then remove the vacuum source line from heater core tube seal, remove seal form heater core tubes, remove three screws retaining blend door actuator to evaporator case and remove actuator from the case. remove the access cover and the seal and you should see the heater core with the tubes sticking out, the rest is history, take out the screws and lift out the core along with the seal from the case.