On the main drive serpentine belt, there is a tensioner pulle. it is positioned at 6:00. relieve tension remove belt. reverse process for reinstallation.
Near the top of the belt there is a belt tensioner; it has a pulley attached to it. It is spring loaded and there is a provision to attach a breaker bar to force back the spring; once you do, it is easy to remove the serpentine belt.
Which belt(s)? accessory belt? the timing belt accessory belt
To remove the accessory drive belt or the serpentine belt from the motor on a 1989 Sunbird, it is necessary to loosen the belt tensioner. Look for a pulley that has a bolt in a slot. Loosen the bolt and move the tensioner so there is a gap in the belt. Then remove the belt from each pulley.
Front of engine (behind serpentine belt).
lokks to be on the lower right side of engine
I believe it to be on the fan belt mechanisim..the pulley that allows you to adjust the tension.
After you have released the tension from the belt, remove the 2 obvious bolts that hold it to the engine block.
Mine did this and I found out it was the timing belt that needed to be changed.
Accessory drive belt.Accessory drive belt.
No, an accessory belt is not considered a serpentine belt. However, a serpentine belt is considered a specific type of accessory belt.
Belt driven accessory lower right side of engine
I think you mean the Supercharger belt? You cannot drive anywhere without your accessory belt... You can drive as long as you want without your Supercharger belt but be prepared for a substantial loss in power.
How do you change the supercharger belt tensioner in 1997 Pontiac Grand Prix GTP?
It could be but the accessory belt could also be a v-belt type belt.
no u can remove belt if that is all that is driven by that belt. if other pulleys are driven by same belt, u need to use smaller belt and bypass a/c pulley
The 2004 2.0 liter Pontiac Grand Am does not have a timing belt, but instead has a timing chain which requires no maintenance.
It does not have a timing belt, it has a timing chain that requires no maintenance.
To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.
Check next page for answer.....same circumstance basically
if im not mistaken..it is behind the timing cover..it runs off the timing belt You are correct. It is the belt tensioner for your timing belt and a pain to release to release the tension and also not the easiest to replace.
Look at the belt on the engine, then look at the pulleys. The water pump is behind the pulley without any groves in the pulley.
Timing belt replacement is a pretty big job. I'd go to the parts store and pick up a Chilton or Haynes manual.
there is no 2.0l Pontiac lemans.it must be a swap from sunrunner.
remove belt pump is accessable remove bolts make sure coolant is drained first replace
The 2.0l VIN K is a free spinning or non interferience engine.