when you open your trunk look to the left or right corners and you will see wing nuts or just simple nuts take these off and the whole assembly should come out for you now its just a matter of unscrewing and replacing the bulb
Unplug the whole light assembly from the bottom front of the car it just pops out to replace the turn signal bulb-same on the rear but you have to remove the trunk lining first.
What does 'service engine soon' light mean on a 1998 olds intrigue?
With a scan tool.
Did you try just turning the ignition key ON but not starting and looking at your dash lights? Usually the dash will light up all lights as a sort of check system.
9006 low beam, 9005 high beam
Turn your key to on, but don't turn the engine on. Pump the gas peddle three times slow and steady under 10 seconds that is. And then turn on the car and the light should go out!
Remove the rear tail light assembly by pulling the carpet back and unscrewing three thumb screws. Pull out the tail light assembly and the bulb sockets will be visible. twist out the socket to access the bulb. Install is reverse.
There is no code associated with the "Change Oil" light like there is with the "Service Engine Soon" light.
Passenger side tail light corner is where my changer is
hard fault code What is a hard fault code?
Our check engine light was on in our 1998 Intrigue. We went to Autozone and they pulled the codes and saw that it was either one (or both because they said there was 2). If your light is not on I am not sure how to find out otherwise. Autozone said that it tripped our light.
The turn signal flasher relay on a 1992 Oldsmobile 98 Recency is in the fuse box under the dash. The fuse is light blue in color.