you should be able to get a thin screwdriver and remove covers at each side of display and there will be 4 screws, remove these pull display forward and remove bulb & holder, you can iether replace the bulb or you can pick up a bulb & new holder ( recommended )
The backlight lightbulb inside the stereo for the display may be burned out ( best case ) or the display itself is bad ( worst case ). How would either senerio be fixed?
To unlock a Clarion car radio in a Peugeot 306, first ensure the radio is powered on. Then, press and hold the "SRC" or "Power" button until the display shows "CODE." Use the station preset buttons (usually 1-6) to enter your four-digit code, pressing the corresponding button for each digit. After entering the code, the radio should unlock and become operational. If the code is incorrect or the display doesn’t change, double-check the code and try again.
To change the clock on a Peugeot 307 with an aftermarket radio, first locate the vehicle's original clock settings, which can typically be accessed through the vehicle's dashboard display. If the aftermarket radio has its own settings menu, you may need to refer to its user manual for specific instructions. Alternatively, you can adjust the clock using the car's original clock settings if the radio has disabled them. If the radio does not allow for easy adjustment, consider reconnecting the original radio temporarily to set the clock.
I don't believe you can display both the radio station and the clock at the same time. With the radio on push the "CLK" button, that will display the time and I believe when you change radio stations it will display the station # temporarily before returning to the clock display.
To remove the radio you need some radio removal piins, put them in the holes on the sides of the radio and push them in, the radio will then pop out and you can pull it out.
Radio code Peugeot bipper
You could request it call them and ask them if they could do that for now on you might change every radio stations!
The eco mode that comes up on your radio display basically stops your battery going flat if you leave your radio on for a long period of time,whilst the engine is not running.
The radio display is usually tied to the dash board lights. As you raise or lower the illumination on the dash, the radio lights should change. During the day (with your headlights off), the radio display is at full brightness so it is easier to read in daylight.
How do you tune in the radio on a Peugeot 107 Active
To change the radio display lights in a Renault Laguna, you'll typically need to remove the radio unit from the dashboard. This involves carefully prying off the surrounding trim and unscrewing any mounting screws. Once the radio is out, you can access the bulbs or LED components for the display and replace them as needed. Always consult the vehicle's manual for specific instructions and safety precautions.
Well remove the radio and there is a master reset on the radio. But if you just remove the positive terminal from the battery it should reset it. And you don't have to remove the radio to do that