Well remove the radio and there is a master reset on the radio. But if you just remove the positive terminal from the battery it should reset it. And you don't have to remove the radio to do that
It seems like your radio is damaged. You can try to reset the system by taking out the battery, if the radio is in your car.
someone hooked up the radio wrong...rewire... if its the original radio...haven't a clue.. Dave answer you have no constant live running to the memory pary of the radio all it takes is to change 2 wires over unfortunatly i forgot which 2 but any mechanic could advise
just disconnect the negatif terminal on the battery for 5 min...and then reconnect,and switch on the ignition wait till 10 sec an then start your engine..
with the radio s/n number you will have to get the reset code through a Honda dealer with the radio s/n number you will have to get the reset code through a Honda dealer
This is a dealer item. They can reset it.
How do you tune in the radio on a Peugeot 107 Active
207 will not start 1.4 hdi above radio it says ecu fault
No, as far as I can see it does not.
There is nothing to reset except the radio presets and the clock.
how do you reset remote central locking peugeot partner
No, all you need to reset is the clock and radio presets.
It seems like your radio is damaged. You can try to reset the system by taking out the battery, if the radio is in your car.
If you mean the radio immobiliser leave the ignition on for ten to fifteen minutes or when you are driving leave radio on and it will reset itself ready for the code. If you don't know the code check your booklet or pull radio out, check all round and if you lucky someone will have put it in either of these places. If not your local Peugeot dealer will be happy to rip you off and supply it. (assuming it original Peugeot radio of course, otherwise cheaper to get a new one).
The immobilizer on a Peugeot 207 can be reset by removing it and reinstalling. Another option is to install a new reader.
Depends on the vehicle you're asking about which you did not list.
Not true. The computer does not have to be reset. You can change it yourself. You may have to enter the radio code if it is a theft deterrent radio but you have to do nothing to the computer.
someone hooked up the radio wrong...rewire... if its the original radio...haven't a clue.. Dave answer you have no constant live running to the memory pary of the radio all it takes is to change 2 wires over unfortunatly i forgot which 2 but any mechanic could advise