Want this question answered?
42" deck = 71" belt48" deck = 73.8" belt44" SNOWBLOWER uses V-Belt 131"
Most LT12H mowers take a #213676 OEM belt or #6885 Gates belt for the blade application
Ford fiesta change the repenting belt
Not an easy task. Never had to remove steering rods and break shaft set up to install a drive belt on a mower before.
when do i change the timeing belt on my 1999 ford transit 100 2.5d
how do u change a timing belt on a 94 ford ranger need help
after how many miles do u change the timming belt on ford focus
how do you change the timing belt in a 2009 fordranger
how do you chance a serpentine belt on a 1996 ford escort
First, I am not a professional and leave you responsible for safety. Remove the old belt... it's good to take note of were it goes but if you can't no worries. If you have a cover on the mower deck that goes over the pulley you will need to remove it... I think it's only 3 screws. Hook the new belt over the pulley (make sure it seats in the groove nicely. Pull the remaining slack of the belt toward the front. You'll notice 2 pulley's in the front that turn up. Both grooved. You'll need to open the cover on the tractor and you'll see on the front on the engine there are 2 pulley's on a clutch. Youll need to seat the belt into the 2 grooved pulleys that turn up (notice one is on a spring and pulls back when pressure is applied.) then push it on the engine pulley. (Use the appropriate one to your belt and mower deck configuration.) You'll probably have to start it and then turn the pulley (again on a clutch so should rotate easily) to get it to feed on. (Also, it will turn the blades on the mower deck so be really careful of what/who is near them.) That should be it. If you really have a tough time and your sure it's the right belt then you can unhook the deck and slide it forward to put the belt on... then the struggle is to hook the deck back on. but some people do find this easier (since the belt won't pull as much since it's all the way in the grooves. By the way... what size belt is it? (I have an LT12 and it didn't have a belt on it... took my best guess but not positive its the right size.)
when do you change cam belt and when do you change timing change
Change the belt