Best Answer

Most owner's manuals have specific instructions and diagrams for the changing of light bulbs. If you have lost your manual, you may still be able to get some kind of aftermarket repair manual for your car at a bookstore that may address this topic in some detail. If all else fails, you can usually find a manual for your car on e-bay, and the manual for a 1996 Contour should be available pretty cheap.

User Avatar

Wiki User

โˆ™ 2006-04-11 19:43:15
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the brake lamps on a 1996 Ford Contour?
Write your answer...
Related questions

How do you change the coolant in a 1996 Ford Contour?

How do you add freon to a 96 Ford Contour

Why is your emergency brake light coming on in your 1996 Ford Contour?

ck break fuild!

How do you turn off the daytime running lamps on 1996 vitara?

Lift the E-brake one click

Where is the fuse for the fog lights on a 1996 Ford Contour?

In the Power Distribution Box in your engine compartment fuse # 5 , 15 amp fuse , fog lamps

Your heater will not blow on your 1996 Ford Contour?

heater will not blow on a 1996 ford contour

How do you change head gasket on 1996 ford contour?

get Jon's mom to do it shes a man but has a manjina

How to replace Brake lines 1996 ford econoline e 150?

how to change brake lines on a 1996 ford econoline e-150

How do you remove the dash panel on a 1996 ford contour?

how to remove the vent from dashboard of 1996 ford contour

Can you get an electrical schematic of the 1996 Ford Contour the brake lights are not working the turn signals are and half of the window brake light is working?

Yes. I have found the schematic in the back of most "Haynes" manuals.

What is the fuse location for a 1996 Ford Thunderbird daytime running lamps?

FUSE BOX located above brake pedal driver side.

How do you change water pump on a 1996 ford contour GL 4-cylinder with air?

water pum instalation for 1996 ford coutour

What fuse or relay runs the brake lights on a 1996 ford contour 4 door sedan?

I would check the brake light switch first. It's a common problem. The switch is located down on the brake pedal and is easy to change. Use a 12 volt test light to check for power at the switch. You've changed the bulbs or checked for voltage at the brake light sockets first?

Why does the third brake light work but not the other two brake lights I have a 1996 Ford Contour?

I am not sure on a ford but i had about the same problem on a GM car i had and it was the turn signal switch i replaced it and all the brake lights worked fine you might try that

How do you change front brake pads on a 1996 Ford Taurus?

what tools are needed

Where is the fuse for your rear breaklight on your 1996 ford thunderbird?

On your 1996 Ford Thunderbird : In the fuse panel under the dash on the drivers side : ( the 15 amp fuse marked STOP / HAZ is the fuse for all 3 brake lights ) * the high mount brake lamp and the stop lamps

How do you change the brakes on a 1996 Chevy Cheyenne?

Remove the tire and wheel from your 1996 Chevy Cheyenne. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.

Is a 1996 ford contour transmission the same as a 1996 ford ranger?

No. The Contour is a front-wheel drive car, and the Ranger is rear wheel drive.

How do you change the timing belt on a 1996 Ford Contour GL?

Well I only have experience on a 2.0 4 cyl what engine are we speaking of?

Will a 1998 contour hood fit a 1996 contour?

No, a 1996 hood will not fit a 1998 because the hood goes around the headlights on each car that are different.

Where is the heater switch located on a 1996 Ford Contour?

The heater switch on a 1996 Ford Contour is under the passenger side dash. It is located behind the glove box.

Where are oxygen sensors located on a 1996 ford contour?

wher are the oxyegen sesors located on a1996 ford contour

Why are the Mercury Grand Marquis 1989 turn signals flashing too fast. Is is the flasher unit .?

I have a 1996 Grand Marquis. If one of the brake lights goes out the signal on that side flashes faster. I would check the brake/tail lamps.

Why does my 1996 explorer running lights stay on?

If you are referring to the daytime running lamps (DRL) on Canadian Explorers not turning off when the parking brake is engaged, I believe that is a defective DRL module.

How do you change your brake pads on a 1996 ranger?

if you are going to go by what people tell you on the internet you need to to get a machnic to do it for you

Where is the Number 1 cylinder 1996 ford contour 4 cylinder?

1---2---3---4 front of Contour