The screws that hold the rear lights in place on a focus are inside behind the rear pillar trim
how change brake fluid . i have ford focus lx 2000.ans how change air filter.
Inside the trunk there is a turnable thumb screws where the brake lights are. Twist screws off and the brake light pops out.
If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.
check the fuse, brake lights have their own, & check the brake switch at the top of the brake pedal
Are you sure you need the fuse for the cruise control. My cruise control wasn't working, neither were my brake lights. All 7 bulbs were burnt out. When the brake lights were replaced the cruise control worked.
it means u have to change your brake lights
Running lights (left side): Fuse #47 -- Running lights (right side): Fuse #48 -- Brake lights: Fuse #54. Fuse panel is on the lower left side (underneath) the dashboard. NOTE: If it is your brake lights that are not working and fuse # 54 looks okay, check the brake light switch, it may have gone bad.
How do you change brake pads for a 2000 Nissan Quest?
Check the brake light switch on the brake pedal
Check the brake switch at the pedal.
Often these are accessed thru the trunk; have you tried that?
check the brake pedal, there is a switch on the back of the pedal that depressed when the brake is depressed that turns the lights on, when this is loose it keeps the lights on.