Want this question answered?
To replace the brake light switch on a Suzuki Forenza, locate it on the pedal shaft, release the wires that connect it, twist and then take out the old brake light switch and put a new switch in its place. The job can be done by any handy owner.
2004 Suzuki Forenza brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
remove the fuse. it's usually onder the dash on the driver side.
the owners manuel will show you that in the trunk under the light there is two screws. you remove them and lift it from inside the back seat.
wire for brake sensor just loose where does it hook to
When the whare sensor starts to squeek
blown fuse under hood check all brake fuses....also could be bad relay at shifter u have to take shifter loose to replace at bottom of shifter
Brake sensor indicator
The brake pad wear sensor is on the brake pads. On my 318ti, the sensor is on the left side, on the inboard pad.
You may have to change the sensor, it's a $9.00 part at autozone.
how do you remove rear brake drum on a suzuki 2004 xl7
You should have a Brake Wear Sensor that will give you the light on your dash when it's time to change brake pads.