0
The brake pad wear sensor is on the brake pads. On my 318ti, the sensor is on the left side, on the inboard pad.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do i replace brake pad sensor on a 2003 BMW 325i?
Carefully pry pad wear sensor from brake pad. Then insert brake pad wear sensor into cutout in new pad where applicable.
How do you reset the brake pad light on a BMW X3?
you have to by a replacement sensor for your front and rear pads.
How do you reset an abs light on 1997 BMW 540i?
how do I reset tne brake pad sensor light on a 1997 BMW 318i
What is a brake pad wear indicator for?
The break pad wear sensor on your BMW is mounted on a front drivers side brake pad and will display a light on your active check control panel when your pads need to be replaced.
How do you turn off brake pad warning lite after putting on 4 new tires on BMW 2004 325XI?
Possible damaged sensor or wiring to the sensor. The pad sensor is located in the brake pads themselves and changing tires will not affect them unless damaged by tire changer
How do you reset the brake sensor light for a 325i BMW?
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
Where is the ABS sensor located in a 2002 C230?
the sensor is in the brake pad itself, it clips in top of brake pad
BMW brake light reset?
Put key in ignition in the second position and open the driver door. should reset in about 10sec.(assuming that you've changed the brake pad wear sensor)
How do you reset brake light on 2006 BMW 525i?
how can i reset rear brake pad warning light on 2006 bmw 525i
Which brake pad wear sensor goes on which wheel of 2003 Mercedes e500?
The E500 Brake Pad Wear Sensor goes on to the wheel of the 2003 Mercedes E500.
Does 2000 jetta have electric brake pad sensor?
Yes 2000 Jetta GL does have front brake pad sensors.
How do you reset the brake pad wear warning light on a BMW X5 after the pads have been replaced?
After your brake pads have been replaced, scroll to the brake pad life display. On the brake pad life display hold the scroll button in until the brake pad life goes to 100 percent.
