0
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you reset oil light on 1989 BMW 325i?
Reset inspection light on 1989 bmw 325i
How do you reset coolant warning light in 325i?
you may need to replace the sensor for the coolant, there should be a wire connected to it.
How do you reset warning light for brakes BMW 2005 325ci?
The brake warning light on a 2005 BMW 325i can be reset by connecting an OBD II code reader. It can view and clear error codes detected by the computer.
How do i replace brake pad sensor on a 2003 BMW 325i?
Carefully pry pad wear sensor from brake pad. Then insert brake pad wear sensor into cutout in new pad where applicable.
How do you reset service engine soon light on a 2003 325i BMW?
reset service engine light on BMW 325
How do you reset the brake light on a BMW 325i?
The Brake Wear Indicator Light means your brakes are malfunctioning, worn out, or low on fluid and you need to get them fixed. If the indicator is caused be worn pads, then the wear sensor has worn through and must be replaced - it's not repairable. After the problem has been corrected, reset the indicator by turning the ignition key to position #2 (just before engine start position) but do not start the engine and wait for less than 60 seconds. The on-board computer will automatically check the sensor condition and reset the indicator if no fault exists. (Note that starting the car and even driving it may not allow the indicator to reset.)
I have a 1995 BMW 325i and I'm getting a brake light circuit message on my display panel. What does that mean?
If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.
1990 325i cabriolet- brake light warning comes on all the time but lights check ok?
fault brake light switch, located at the top of the brake pedal.
Reset 2006 BMW 325i brake light?
Hold trip button in,watch message center to see brake lining indicator light comes on,release button,push button on turn signal lever in,reset message appears,push same button once more (hold it there till the hour icon disapears).Done.Hope this helps. 10inja
How do you reset engine check light on 1995 BMW 325i?
You need a scan tool to plug into OBD port
How do you reset 2003 BMW 325I computer?
Check out the realted link for some advice on how to reset the computer in your 2003 BMW 325I computer.
How do you reset the service engine soon light on a BMW 325i?
Have vehicle scanned to determine the problem (usually in the emission control system) and have codes cleared
