0
The Brake Wear Indicator Light means your brakes are malfunctioning, worn out, or low on fluid and you need to get them fixed. If the indicator is caused be worn pads, then the wear sensor has worn through and must be replaced - it's not repairable.
After the problem has been corrected, reset the indicator by turning the ignition key to position #2 (just before engine start position) but do not start the engine and wait for less than 60 seconds. The on-board computer will automatically check the sensor condition and reset the indicator if no fault exists. (Note that starting the car and even driving it may not allow the indicator to reset.)
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you reset oil light on 1989 BMW 325i?
Reset inspection light on 1989 bmw 325i
How do you reset service engine soon light on a 2003 325i BMW?
reset service engine light on BMW 325
How do you reset the brake sensor light for a 325i BMW?
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
How do you reset warning light for brakes BMW 2005 325ci?
The brake warning light on a 2005 BMW 325i can be reset by connecting an OBD II code reader. It can view and clear error codes detected by the computer.
How do you reset brake light for 2004 BMW 745?
how do you reset brake warning light 0n 745li bmw
How do you reset brake light on 2006 BMW 525i?
how can i reset rear brake pad warning light on 2006 bmw 525i
How do you reset 2003 BMW 325I computer?
Check out the realted link for some advice on how to reset the computer in your 2003 BMW 325I computer.
How do you reset an abs light on 1997 BMW 540i?
how do I reset tne brake pad sensor light on a 1997 BMW 318i
I have a 1995 BMW 325i and I'm getting a brake light circuit message on my display panel. What does that mean?
If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.
How do you reset BMW 525i 2007 brake light?
You will need a compatible BMW scan tool to reset this service light from the I drive system.
How do you reset engine check light on 1995 BMW 325i?
You need a scan tool to plug into OBD port
When to service BMW x5?
Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.
