The following is how I change my blub on my 2002 Z24 Chevy Cavalier Coupe. FYI: Have a good amount of time to complete this!.
First you will have to get down and dirty and get under your Cavalier (I didn't raise my car up...this may have helped, maybe).
Second the foglights on my Cavalier had a two point screw system holding them to the frame of the car. We will need to remove these to get the foglight out, and then change the bulb. There are two screws in total (10mm on my car) one screw is either in the upper corner and then one on the opposite lower corner or...to help you picture this think of were the foglight attachs to the frame as a square.
My car had very, very little hand room to remove this screws and I spent about 95% of my 2 hours removing and re-attaching these screws.
After getting these two screws of each foglight just wiggle the foglight out from the front of your car.
Next just simply rotate the bulb attachment counterclo.ckwise...if i remember correctly. Take the old bulb out and put your new bulb in and rotate clockwise to lock back in.
Re-insert the foglight back into the body of the car making sure that both screws go back into the holes.
Re-attact each screw on the back of the foglight under your car.
Repeat this on the other foglight...NOW YOUR DONE!
This will take some time...at least it did for me, maybe because it was raining. TIP: If its raining move to your garage or just wait for a nicer day ha.
Hey.... I just changed out both bulbs on my '02 Z24 and it took me about 5 minutes. Here's what you do -
Lay down in front of the car and reach in behind the foglight assembly. Turn the connector about a 1.4 turn counter-clockwise and the bulb and connector will come right out. Remove the bulb from the connector (you're going to have to stick your head onder the car to see what you're doing). Plug a new bulb in and reinsert the whole deal back into the assembly. I'f you're having trouble aligning the bulb right turn on your lights and you'll be able to see where the tabs align by looking though the lens.
You can find a complete bulb reference at http://www.whatbulb.com and for your car specifically here: http://www.whatbulb.com/2000-Chevrolet-Cavalier
Remove the light assy and turn the bulbs counterclockwise.
i wanted to know how to change head light bulb of 99 cavalier
how do you replace a bulb in a fog light on a 2000 maxima?
how do you change the light bulb over the license plate on 2000 eclipse
You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny
It comes out the back of the light housing.
You can replace the dome light bulb in a 2002 Chevy Cavalier by first prying the dome light cover off of the light. Then, remove the bulb and replace it by twisting the bulb from the socket.
To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.
Replacing a front signal turn bulb on a 2000 Chevy cavalier takes all abut a few minutes to complete. First find the housing for the turn signal which is located in the engine compartment. Pull back the bulb from the light housing and remove it from the clip. Lastly install the new light.
ho change the head light bulb in a 2000 ford f- 150
light bulb out on map light how to change with out breaking plastic lens