for a 6.0L engine the cam sensor is located on the side of the block behind the Power Steering pump. disconnect the wiring connector, remove the 8mm bolt, remove sensor and reverse to install.
where is a cam sensor on a 2006 ford f250 6.0L diesel engine?
its under the water pump
possible weak batteries?
I think the bolt is a 10mm then pull it out. Have not had many problems with the 6.0 cam sensor like the 7.3L
A 10mm socket and a flat head screwdriver (to assist in prying) is all that is required.
Does not have a cam sensor on a 7.3L IDI this engine is not computer controlled.
passanger side of water pump
check the cam position sensor
cam sensor on a diesel??????????????????? yes cam sensor on a diesel. a diesel still has valves that are opened by a camshaft to allow air in and out of the combustion chambers, and it's necessary for injector timing to know what position the cam is in. 7.3L cam sensor is located at the front of the engine just above the harmonic balancer. (this sensor is often replaced if you have a p0344 or p0340 code.) very easy to change, you just need a 10mm socket preferably 1/4" drive and a long flat blade screwdriver. 6.0L cam sensor is located on the drivers (LH) side of the engine block near the front of the engine. The 6.0 cam sensor is behind the power steering pump. You need to remove the belt and the p.s. pump bolts and swing the pump away from the block. This will expose the cam sensor(which is about 5 inches long) and it's 10 mm bolt, after which you can pull the sensor from the block.
To change a 305 cam sensor, locate it beside the camshaft. Disconnect the electrical plug of the sensor and remove the hold-down bolt to take off the cam sensor. Replace with new.Ê
No it will not start need to change the cam sensor & crank sensor!
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley