possible weak batteries?
No, The pcm has to see a signal from the sensor
change the crank position sensor
crank sensor or cam sensor
spark? fuel?
Dead batteries Failed starter Out of fuel Fuel filter plugged Lift pump inoperative Injection pump failure Crank sensor failure ECM failure Wiring issue to ecm or sensors.
check fuel pressure regulator
I was driving on the highway and the car just stalled and wouldn't restart. Originally it showed a code for cam position sensor. I changed the cam pos sensor. It still wont start. When I try to start it it cranks much faster than normal. Now it shows a code for a MAP sensor. I changed that...nothing. Any ideas.
poo
Was that the only code that caused you to replace it? Do you have it close enough to sense again.
if it is getting fuel and spark it could be the map sensor
it has to be reset if you disconnect the battery for a few minutes should do it
On a diesel, the TPS or APPS (accel pedal position sensor) is part of the accelerator pedal.On a Hemi, the TPS is a non-servicable part of the throttle body. The APPS is still part of the pedal.On a diesel, the TPS or APPS (accel pedal position sensor) is part of the accelerator pedal.On a Hemi, the TPS is a non-servicable part of the throttle body. The APPS is still part of the pedal.