Car Computers and Sensors
1995-1999 Dodge & Plymouth Neons
Chevy Trailblazer

How do you change the cam sensor on a 1997 Dodge Neon?

161718

Top Answer
User Avatar
Wiki User
2007-05-11 17:09:56
2007-05-11 17:09:56

I just did this 1 week ago. First disconnect negative battery post. Remove big plastic air filter cover and air intake hose that is connected to it. While standing at the front of car looking down on the right (drivers) side of the head, you will see a square black part held on by 4 10mm bolts( they are not fun to get at, you will need a 10mm socket and 10mm wrench)you will see an electrical connector going to the bottom of it. I found it easier to remove the part and then undo the connector. Then put the new on the same way you took the old one off. Put all parts back on and reconnect negative battery post. Pretty easy really and I'm a chick. LOL!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

A Dodge Neon does not have a mass airflow sensor.

User Avatar

A Dodge Neon does not have a mass airflow sensor.

User Avatar

Driver side end of the cylinder head.

User Avatar

on the driver side of the engine right below the cam sensor on the head.

User Avatar

A 2000 Dodge Neon does not have a maf sensor.

User Avatar

Yes, a Dodge Neon has a coolant temperature sensor.

User Avatar

A Dodge Neon does not have a mass airflow sensor.

User Avatar

A Dodge Neon does not have any such part.;

User Avatar

There are 2. Both are on the exaust pipe before and after the catalytic converter.

User Avatar

Rear camshaft seal bad. Replace. located behind cam sensor.

User Avatar

There definitely is a crank position sensor on a Neon

User Avatar

A Neon does not have a shutdown related to the oil sensor.

User Avatar

The coolant temperature sensor on a 2005 Dodge Neon is located on the cylinder head. It is close to the camshaft position sensor.

User Avatar

The sensor behind the oil filter for a 1998 Neon is a crankshaft position sensor. Unplug the wiring and remove the hold down bolt to replace it.

User Avatar

there is a bolt off to the right off the sensor take it out and it should just pull right out.

User Avatar

The IAT sensor on a 2004 Dodge Neon is on the intake manifold. It is inside the number two intake runner.

User Avatar

Change in MAP sensor reading beyond limits.

User Avatar

nthow to change the beltson the dodge neon

User Avatar

The throttle position sensor is not adjustable.

User Avatar

http://www.techknowman.com/Dodge%20Neon/Dodge%20Neon.htm

User Avatar

One is before the cat. converter and one is between the cat. converter and the exhaust mainifold.

User Avatar

The Dodge Neon does not have a MAF (Mass Air Flow) Sensor. It does, however, have a MAP (Mass Air Pressure) sensor located on the intake manifold between the two left runners.

User Avatar

The speed sensor for a 1995 Neon is on the side of the transmission. It is mounted behind the vehicles exhaust.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.