0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where can you get a vacuum line diagram for a 1989 Isuzu Pickup?
Go to http://ww.mitchellrepair.com
Estimated cost to replace 1989 Nissan 4wd pickup clutch and radiator?
The estimated cost to replace a clutch and radiator, in a 1989 Nissan pickup truck is $1100. A private mechanic may be able to do the job for less.
Your 1989 civic manual transmission is hard to shift?
If you clutch is working fine then try to change the gear fluid in the transmission. My Isuzu shifted hard to and the fluid changed helped alot
What are the timing specs for a 1988 Isuzu Trooper 4-cylinder 2.6L engine?
on a 1989 Isuzu pickup with a 2.6 same engine 12 degree b.t.d.c. at 900 rpm
How do you change the clutch on a 1989 Toyota MR2 turbo?
Take the trans out, the clutch is inside the trans ^_^
Where is the signal and hazard light flasher on a 1990 Isuzu Pickup?
on a 1989 Isuzu pickup you need to take out the left speakerto get to the signal and hazard light flasher ..The control box for the flashers and turn indicators is all contained within the steering column. Not the easiest to get to.
How do you change the clutch on a 1989 dodge colt?
Take out the transmission
1989 Isuzu pickup truck what is the proper way to install the fuel sending unit. please help thanks?
IF I KNEW I WOULD NOT BE ASKING
What is wrong with a 1989 Dodge 318 pickup if it lurches has loss of power and idling issues?
Bad lockup clutch in the torque converter possibly.
Where is the starter on a 1989 Isuzu pickup?
Starter is on the left hand side (if standing in front of car) under the carburettor next to the engine block bolted on the gearbox
Your clutch fluid is leaking near the passenger side of the trans on your 1989 Chevy pickup what could it be?
Perhaps slave cylinder, line or fitting leaking?
How do you adjust the slave cylinder on a 1989 Chevy pickup 1500?
There is NO adjustment, You must replace the clutch set to bring the pedal back to the right position. You also need to make sure the clutch slave cylinder/ master cylinder is good before replacing clutch assy.
