first you remove shiter boot and remove shifter and you dismount driveshaft or shafts if 4 wheel drive un hook the wiring for the transmission and transfer case if 4 wheel drive remove the clutch slave cylinder undo all the belhouse bolts put transmiss jack under transmission and remove rear cross member pull the transmission toward the rear so that the main shaft is clear of clutch the exhaust may have to be removed lower transmission onto ground take the clutch mount bolts off and then remove the fly wheel and get the fly wheel cut when re assemblem use a clutch linin tool too install clutch properly lined this will alow main trans shaft to go through clutch easier
what are the years and kinds of Automatic transmissions that will fit in a 2.3l 97 ford ranger 4x2
Use a strap wrench or similar device to keep it from turning.
Depends on what you are trying to swap. Most parts are some are not.
You have to take the transmission completely out of the vehicle. Hope this helps. Clay Colorado.
FYI I used a hand held vacumm brake bledder. remember air is expandible oil is not. This should remove over 97% of air in your clutch system. Good luck Paul
P1151 and obd fault code solution for a 97 ford ranger
The transmission is bolted to the back of the engine
not fuses or relay?
it does.my 2.3 ranger has one so yours should
Exterior panels: 93-97 Bed: 93+ Interior Panels: 95+ www.FordRanger.net
According to the 1997 Ford Ranger Owner Guide : With engine oil filter change : The 3.0 liter V6 engine takes : ( 4.5 U.S. quarts / 4.3 liters of 5W-30 )
What is the average cost of a 97 ford ranger automatic transmission 4 Wheel drive Extended cab