You have to split the engine cases and remove the crankshaft. Then remove the crankshaft bearings. Use a seal driver or large socket and knock out the seals. Lube new seals and drive them in. Replace all the seals in motor, new crank bearings, and mine as well throw in a new piston and rings since its all apart anyway.
the front or rear seal on the timing chain side
Took me about an hour to change mine, but it was the first time.
you have to separate the engine and tranny to have access!! very labor intensive
not an easy task but you can deffinatly do it. your gonna need the whole front rnd though forks triple tree ect.
The crankshaft position sensor can be found on the bottom of the engine in a 2000 Honda Civic EX. It is next to the crankshaft itself.
Take off the old one and put the new one on.
near the crankshaft
Crankshaft is inside the lower part of the motor.
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
About 50.
The crankshaft sensor for this model is located at the front of the engine, near the crankshaft itself.
What is the spark plug gap on a kawasaki mojave 250