0
It would be easier and quicker to swap out the axle assembly for a rebuilt unit than to try to successfully replace just the boot. If the boot has been torn open for sometime the joint is probably on it's way out anyway.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the cv boot on a 1991 Nissan Stanza?
you cannot just change the boot you will have to replace the whole axle
How do you change a CV boot on a Ford Escort?
It is cheaper to replace the CV shaft than it is to replace the boot. If the boot has been torn for any length of time it will have collected dirt and water. That in itself spells disaster.
How do you change a CV boot on a 1999 Mercury Villager?
Changing CV boots is not cost effective. It is much simpler to simply swap in a rebuilt CV shaft.
How do you replace a rear cv boot on a subaru wrx?
Lift the vehicle using a jack. Inspect the CV boot for problems. Mark the axle. Separate the CV from the shaft. Remove the CV boot clamps. Use a mallet to knock the CV joint off the shaft. Remove the boot from the CV axle shaft.
How do you change a CV boot on a ford probe?
there's a product you can purchase at most auto parts stores called a split boot. this eliminates the need to remove the cv joint from the vehicle.comes with instructions on how to apply..
Is cv joint same as the front axle where the rubber boot is?
The CV joint is the part inside the boot.
How do you change the cv joint boot in a 2000 Kia Spectra?
You can buy a CV joint boot kit and install it fairly easily if you can find a boot that bolts together in the center. Just cit the old boot off, put the new boot on , install the grease, bolt up the sides, and put on the hose clamp.
How do you change the cv boot on a 1989 Chrysler new yorker?
forget about changing just the boot-its easier and faster to change the whole axle assembly and you dont need all of the special tools
How do you change a CV joint on a 1997 Honda Civic?
If the CV boot is torn open forget about re-booting the joint, buy a remanufactured axle and replace it. If the boot is starting to crack or separate but has not torn open to the point you can see the cv joint itself you can re-boot it.Replacing CV JointsThere are places that sell the halfshaft axles already rebuilt as cheap as you can replace the joints. Call your local parts stores.
CV boot Ford Ranger how to replace?
A CV boot is found on the axle of a vehicle. To replace the outer boot remove the axle bolt and pull the boot off. The inner boot requires removal of the whole axle.
Can a cracked CV boot cause noise in the CV joint?
A cracked boot itself won't cause a CV joint to make noise. However, a cracked boot WILL cause the grease to be slung out and allow dirt to enter the CV joint. And a contaminated CV joint that is starved for lubricant WILL eventually start to make noise.
How do you change the CV boot on an Infiniti QX4?
remove axle, separate joint inner or outter joint, clean, regrease, and put it back together with a new boot
