wich fuse goes to my dashboard lights on a 1991 potiac fire bird
Check the fuse box.
how do you get to and change the front parking lights on a 1991 civic hatchback si?
check fuses. check bulbs. check wires. If not any of those, good luck.
you need to change the flasher can for the signal lights
any other year beretta 87-96
Ford didn't make a Beretta, so there is no answer.
If by 'controller' you mean the switch that makes the brake lights come on, it is not in the trunk. It is located underneath the dashboard, next to the brake pedal.
There is no such vehicle as a Ford Beretta. Chevrolet produced the Beretta, not Ford. The 1991 Chevrolet Beretta uses a 195/70-14 The Beretta GT uses a 205/60-15.
There is a big hose in the front valve cover it is at the end of that hose...
reset the brakelamp light on the dashboard - Honda prelude 1991
You can remove the panel inside the back of the car. From there you can access your tail lights and your tag lights.
yes it is
The vacuum hoses are very important in a 1991 Beretta. Without the vacuum lines, the engine will not run properly, and the power brakes will not function.
I had a similar problem with my 1991 Maxima. The dashboard lights did not work. I could not find a fuse. Then I noticed the parking lights did not work. I could not find a fuse. Finally I noticed the tail lights did not work. I checked the fuse and it was burnt. After replacing it all is okay again.
Hazerds lights and blinkers done work
The dashboard on a 1991 Honda Civic is held on by several screws. Loosen and remove all of the screws. Then proceed to pull the dash out.
Typically this is a failure of the headlight switch assembly. See the question about how to replace the headlight switch in a 1991 Cherokee for the answer of how to accomplish.
In the fuse box located under the driver's side dashboard. That fuse is between circuits for air suspension, dash, lights, and a few accessories. Use a multimeter or lamp to find the blown fuse.
On the front left of the engine.
I have a 1991 Chevy surburan and it has no tail lights and no dash lights, all fuses are good
Start by checking the fuse in the fuse panel. Also make sure the dimmer switch is not turned off.
Usually a fuse. when the fuse blows the dash lights AND tail lights dont work. If your tail lights work and dash lights dont, check bulbs, if all blown at once you may have a shorting problem. If bulbs are good you may have a bad connection. Tracing wires is a big job. Get yourself a good quality test light.
Pimp your car