The method of changing the deck belt will vary wildly with the many available decks, but there are a few common steps.
1: Remove the deck. (not necessary but recommended)
2: Notice the way that the belt is wound around the spindles. Take a picture if necessary.
3: Remove the belt. There will usually be a tensioning pulley that is pulling the belt tight with a spring. Remove the spring and release the pressure to pull the belt off.
4: Buy a new belt. Either find numbers on the belt, measure it, or bring it to a hardware store that can help you find the right size for your deck.
5: Install the new belt. Recall how it wound around each spindle and pulley, and install it. Replace any tensioning springs you might have removed.
6: Reattach the deck and try it out! There shouldn't be any vibrations or unusual noise.
Note: These steps are very general and vary by the individual deck.
How do you change a mower deck belt on a John Deere L130?Read more: How_do_you_change_a_mower_deck_belt_on_a_John_Deere_L130
make a drawing of how the old one is on it before replacing it,
Disingage the mower deck take off the mower deck look under neath their and replace the belt
Impossible to answer without knowing year, make & model, of mower.
You can change a John Deere LA 175 mower deck belt configuration by checking the diagrams and instructions in the owner's or manufacturer's manual basically.
With proper replacement belt in hand, lower deck. ÊRemove grass catcher. ÊLocate the the locking mechanism, unlock and lower deck to the floor. ÊRemove the belt, wearing leather gloves, slide the belt around the engine pulley, a small screwdriver may be helpful.Reattach the grass catcher.
what model and which belt? If it is a 1000 series you have a transmission drive belt and a deck belt. I you have a 2000 series or higher or a cub cadet with an IH logo then you only have one belt the deck belt and no drive belt you have a drive shaft. So the model of the tractor and what belt needs to be given before the correct answer can be given.Phil
You can change the drive belt, on your lawnmower, by loosening the tensioner pulley. With the tensioner pulley, loosen the drive belt will come off and can be replaced.
A Craftsman belt number 9180R or a Gates belt number 6841
John Deere 210 38" mower deck drive belt: M40223 secondary drive belt
you were no help
42" deck = 71" belt48" deck = 73.8" belt44" SNOWBLOWER uses V-Belt 131"