Unscrew the screws holding the cap and lift it up and away from the distributor. Pull the rotor straight up and install the new one.
It is inside of the distributor under the cap and rotor. It is the only electronic item in the distributor.
It is mounted in the distributor under the rotor button.
It is in the distributor under the rotor button and it is the only electrical device that you will see in there.
remove the distributor cap and grab the rotor then pull straight up.
The easy way is to replace the entire distributor with a remanufactured unit. The hard way is to mark position of distributor rotor, remove the distributor from engine,reome cap & rotor, remove drive gear from the bottom of distributor , slide shaft up & out, remove pick up.reverse steps & reset ignition timing. IMPORTANT TO MARK LOCATION OF ROTOR BEFORE REMOVAL
It's located in the distributor under the rotor.
as far as i know there isn't a rotor there for there isn't a distributor. I'm i right ?
If you remove the distributor cap and rotor then you will see the cam sensor bolted on the distributor and it will have an electrical connector pluged into it.
buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.
It is the only electrical part that's in the distributor. Remove the cap and rotor and you will see it.
change the rotor. spark shorting to distributor shaft
The pickup coil in the distributor? !976 should be an HEI distributor. Take the cap off, unplug the wires going to the distributor, remove the rotor and the pickup coil is under the rotor and held in place with two screws.