The pickup coil in the distributor? !976 should be an HEI distributor. Take the cap off, unplug the wires going to the distributor, remove the rotor and the pickup coil is under the rotor and held in place with two screws.
Find your distributor cap and follow the center cable to a rectangular part. This is the ignition module. Remove it, get a new one and install it.
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
The 327 cubic inch Chevrolet's distributor had points and condenser and not an ignition module. If you have an ignition module then you have a HEI distributor that was changed out.
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
It is inside the distributor.
It is inside of the distributor.
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
The module is located underneath the coil packs.
am told my ignition module on my SL 500 is faulty where can i replace this and what exactly does it do?
You need to be more specific as to what you are referring. I am not sure if you are referring to the ignition switch or module.
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
To replace the ignition module in your Celebrity: Unplug the wires, take note of where they go so you can put them back in the correct place. Remove the screws that hold the ignition module in place. If the old module was coated with dielectric grease on the mounting surface put fresh dielectric grease on the replacement ignition module. Put the new ignition module in place and attach with the screws. Plug the wires back in their respective places.