Want this question answered?
A Lens
Remove the tail light cover in the cargo compartment. Remove the wiring harness. Remove the blinker retaining screws. Reverse the process to install the new blinker.
inside rocker cover
if the bad blinker is the small, rectangular one in the gray bumper, all you need to do is get a Phillip's head screwdriver, remove both screws from the front blinker, remove the orange plastic cover, and then the bulb actually pops out itself with a quick wiggle. easy as pie, and the replacement bulb is quite cheap as well.
You remove the headlight to gain access to the back of the blinker housing, you can reach into the back of it and pull out the light and cable it's attached to. It's a pain.
you have to replace the whole module if I am not mistaken, first remove the steering wheel cover and then there should be 2 pins you will have to get to and push simultaneously to remove
If the blinker is not working on a Mazda 121, check the turn signal flasher. If the bulb needs to be replaced, remove the lens cover and insert a new bulb.
Under the plastic cover just below the windshield on the right hand side side. You don't need to remove the cover to change the filter, it is enough to lift the front of the cover and reach in to release the filter. It is a bit tricky since it is pretty tight, but it can be done.
by blinker I assume you mean turning signal. The fuse is located under the dash board, driver side. It's a little black fuse box, the cover of the box should tell you what fuse is for what.
They don't have a timing belt, they have an internal timing chain instead which is supposed to last the life of the engine. However, with high mileages and/or infrequent oil changes the chain can become rattly and needs replacing. The chain and sprocket kit is less than £20 but you'll also need to replace the sump gasket, timing cover gasket and oil seal and a new oil filter and oil. Altogether about £35 from Jorily in the UK not including the oil.
There are 2 screws on the inside of the bed if you drop the tailgate. If you take those out, the whole taillight will come out and then the blinker, taillight and reverse bulbs are twisted in 3 different spots.
Open the boot, remove the screw from beside the boot opening. Push/lever the lens cover outwards towards the side of the vehicle(there are two lugs on the front outside of the cover. Twist to remove the bulb housing. Replacement is the reverse of above.