Brake Pads and Rotors
2000-2005 Dodge & Plymouth Neons

How do you change the front brake pads on a 2004 dodge neon?

171819

Top Answer
User Avatar
Wiki User
2007-12-24 07:30:40
2007-12-24 07:30:40

first caulk the rear tire, then break the lug nuts while the tire is still on the ground. lift the tire with a jack and remove the lug nuts. remove the wheel and find the two bolts on the caliper with a small rubber grommet protecting the bolt (they are towards the front of the caliper on the backside.) remove both bolts, and rock caliper off of the rotor. push on the back of the break shoes and pop them out and then push the caliper piston back. install new break pads by pushing them back into the location of the old ones. rock the caliper back onto the rotor and re-bolt it to the mount. install the wheel and lug nits, tighten, then torque when the wheels on the ground again, repeat on the other side.

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you chage bracke pads on a 355 2004 dodge diesel truck

User Avatar

what size allen wrench do i need to change front brakes on a 2004 dodge grand caravan

User Avatar

Change the brake pads sensors. You must change them after every brake pad swap.

User Avatar

The 2004 Dodge Durango has 59.3 in. of front shoulder room.

User Avatar

The 2004 Dodge Durango has 41.5 in. of front leg room.

User Avatar

The 2004 Dodge Durango has 40.8 in. of front head room.

User Avatar

The 2004 Dodge Durango has 58.7 in. of front hip room.

User Avatar

The front track of the 2004 Dodge Durango is 5 ft. 4.4 in. (64.4 in.).

User Avatar

How do I change a thermastat on a 2004 dodge stratus se ?

User Avatar

Answering "How do you replace the brake pads on a 2004 Dodge Durango limited with anti lock brakes?"

User Avatar

The left front speed sensor is electric and does not have a cable. The sensor is accessed by removing the brake rotor.

User Avatar

The front track of the 2004 Dodge Grand-Caravan is 5 ft. 3 in. (63 in.).

User Avatar

how do you change a thermostat on a 2004 dodge ram 2500 series

User Avatar

How do you change rear brake drum on a 2004 Chevy Venture?

User Avatar

no, the offset around the brake caliper is different.

User Avatar

No, the 2004 Durango is a completely different brake system.

User Avatar

No the depth of the wheel will hit the front brake caliper. it will not be obvious until you go to move.

User Avatar

You rem ve caliper, remove old pads, fit new ones.

User Avatar

2001 forerunner front brake replacement

User Avatar

Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.

User Avatar

The brake pads on a 2004 Dodge Ram 2500 4x4 are replaced by removing the wheels, unbolting the calipers, and taking out the brake pads. The caliper piston must be pressed back in before new pads are installed.

User Avatar

common metric socket set, brake fluid, brake pads, some of that brake quiet crap auto zone always give you, heavy duty flat head.... a jack, and a little know how, and time


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.