There are two screws on the the door panel.
You have to remove the whole dashboard and then the speaker should be exposed, then just remove it.
go to http://www.carstereoremoval.com and for $3 they will show you how to do it ,with pictures and you can print out the directions, it's easy and the web site is good for all cars....
The 2004 fits 6x9 in front and rear and 3.5 in the dash.
Front center of the engine, behind the motor mount bracket.Front center of the engine, behind the motor mount bracket.
3.5" in dash (if equipped) 6x5 in front doors 6x9 in rear deck
center front of the engine. Behind radiator side engine mount.
what is a Chrysler 2004 I am not up to date with this model of car.
i wana change speaker for 2003 Honda accord
FRONT SEATING AREA, CENTER, PASSENGER SIDE OF STEERING COLUMN, MOUNTED IN FRONT OF CONSOLE.
Center front of the engine, just above the oil pan.
The Speaker Sizes for a 2008 Chrysler Sebring Convertible are as follows: Front Dash: 3 - 1/2" Front Doors: 6 - 1/2" Rear Seat 5 - 1/4" Side Panels
Underhood left front power distribution center
There are four mounts. Center left, right, front, and rear.
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
3.5 in tweeters in the dash and as far as i know my 2004 has 6x9s in the front doors and 6x9s in the rear shelf
You need to remove the Interior door panel. From there you can gain access to the speaker and replace it as needed.
Front Power Distribution Center Fuses, #4 - 20 Amp Yellow
Remove the center console. The module will be in front of console under dash
There are many different types of speakers one needs to consider for a car speaker system. A complete set consists of a a set of front, center, and rear speakers.
You have to remove the door panel, after that you will be able to replace the speaker.
For the front door speakers in a 1997 Honda Civic, the left front speaker wire (+) is blue and the left front speaker wire (-) is gray/black. For the right side, the front speaker wire (+) is red/green, and the right front speaker wire (-) is brown/black.
You will need to remove the front speaker covers. The speaker covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new speakers.
Yes. A Chrysler 200 is front wheel drive.