answersLogoWhite

0


Best Answer

You will need to remove the tire and wheel from your 1986 Honda Accord. Remove the brake caliper and the brake spring. The disk brakes will come off. Reverse the process to install the new front disc brakes.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the front disc brakes on a 1986 Honda Accord?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does the Honda accord have front and rear brakes?

Of course. All vehicles have front & rear brakes.


95 Honda accord lx how do you change front brakes?

http://www.superhonda.com/forum/f13/front-brake-rotor-replacement-procedure-95-accord-331025/


What type of brakes does a 1998 Honda Accord use?

Disc brakes in the front and rear drum brakes.


What Type of brakes for 1992 Honda Accord ex?

Disc brakes in the front and drum brakes in the rear.


How do you change the front and rear brakes on a 2002 Honda Accord 4 door LX?

Not to hard to do but you need direction. Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM


How do you change the wheel bearing on a 1998 Honda Accord ex?

how do you change a 1998 Honda accord front wheel bearing


How do you change the front two speakers in my 2003 accord?

i wana change speaker for 2003 Honda accord


How do you change brakes on 1999 Honda civic?

front or rear


Is the back brakes on a 1994 Honda accord the main brake?

No, most of the stopping is performed by the front brakes. But Honda uses a braking system that applies the rear brakes first. For this reason the rear brakes on some Hondas will wear out first.


How do you change 1993 Honda Accord LX back disc brakes?

Pads: Similar to front disk pads, except that the caliper piston is retracted by turning clockwise, not pushed directly in.


How much for front brake job on 1995 Honda accord?

Just got my front & rear brakes done with rotor resurfacing for $380 in Burbank, Ca.


How do you change the front rotors on a 1999 Honda Accord DX?

they have to pressed out from a machine shop.