youll need a torx bit to remove the mounting (4)screws on the side marker light bezel.pull it out carefully and reach behind to remove the bulb socket,slighly press down and rotate to release the bulb.from the socket,when you put it back on make sure the bulb socket is seated properly in the bezel,so that water doesnt go in and it wont comes loose.
Tools required are a 4mm socket to adjust the lamps with the bubble levels located on the headlamp assy.
Check the bulbs they are double filamented with the smaller being used for the stop lights
if you disconnect it you will have a fault code stored in youy ecu and will cause problems like dome lamps staying on all the time..
No Dodge Challengers were made in 2007.
I would not ask here, but at 3si.org, and a great parts store is 3sx.com that has all types of modification for the 3000gt/stealth
assuming you mean the light bulbs, see the answer to "how do you change turn signal lamps both front and rear on a 96 mercury grand marquis" right here in WikiAnswers.
Check bulbsCheck switch
Amber.
There are 3 screws located under the front bumper under the light you need to replace take these 3 screws out and you have full access to all the lights in front. do this for each side.
Amber
NO! Each lamp on the vehicle is individually replaceable. Front lamps are accessible from inside the engine compartment. On the back side of the lamp assembly the lamp socket is held in place by a clip that either twists to release or by lifting a latching finger. Rear lamps require the lamp assembly to be dismounted from the vehicle and then the lamps are accessible from the backside. Avoid touching the lamp with bare hands. Body oils on your skin can cause a hotspot on the lamp and a shortened life. Better to use a dry paper towel to handle the lamp.
Could be fog lamps.