There is a two screws on the inside of the bed where the tailgate sits when up. Remove screws and the entire lens assembly can gently but firmly be removed and access to all the taillamp bulbs is achieved. The headlamps are a little trickier, there is a "floating" lock ring on the back of the headlamp that will release the bulb connector and allow acces to the bulb. Quick tip, leave the lock ring on the harness die to the fact it fits only one way to save frustration.
you have to remove it from the outside.after you remove the screws press the bulb and turn it to the left to remove.
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
Replace the whole light assembly Their are no bulbs it is neon light
Unscrew the grey pannel off of the talilight assembly to gain access to the light bulbs, then the bulbs remove from the pannel by simply pulling them out.
you need to remove the taillight assembly. you will see all the bulbs.
Take out the old one and put in the new!!
The bulbs screw in from the rear. There are screws holding the light assy on and youhave to take them out to take the light off.
When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.
check fuse and bulbs...switch
no
You have to remove the instrument cluster to get access to the bulbs.
check the tail light bulbs