Open the hood. Standing in front of the car, there are two screws on top of the headlight housing. I believe they are 8mm. When you remove them, the headlight assembly is loose and can be moved out far enough to reach the rear connectors on the lamps and bulbs contained in the headlight housing. Grasp the lamp connector at the back of the housing and turn in about 1/4 turn clockwise and remove the lamp. When installing the new lamp, don't touch the new lamp with your bare fingers. The oil from your fingers will cause the lamp to turn dark and shorten the life of the lamp. Install the new lamp and headlight assembly in the reverse order.
A 2002 Chrysler Sebring was not built with a cabin filter.
Read the manual.
A 2002 Chrysler Sebring convertible does not have a maf sensor.
No, in 2002 the Chrysler sedan was a Sebring.
change the heather fan sensor
A 2002 Chrysler Sebring sedan does not have a MAF sensor.
All there is to do is to change the fluid and the filter.
Yes, you unplug and unscrew them.
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.
Idle speed is computer controlled and is not adjustable.
The 2002 Chrysler Sebring OBD 2 port is underneath instrument panel, near steering column
I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off. You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.
It does not have one.
every 5000 to 8000 Km or every 4 months