Ignition coils are easily accessable on top of the engine. Disconnect the electrical connector, unscrew the bolts (2 per coil, torx T-25), pull the coil straight out. Cylinder numbers are: Pass side, front to back - 1, 3, 5. Driver side, front to back - 2, 4, 6.
The Kia Sportage has Two ignition coils, they sit on the top side of the engine On the spark plugs, each coil serves two plugs. The plugs are located on the top of the head and to get to them you need to remove the air intake to the throttle body, There is a black cover plate about 4 inches wide held down by I believe 6 bolts, remove the cover and there you will find the coils.Each coil is helld in place by 2 bolts. Good luck. Tony.
Begin by removing the retaining ring at the top of your 1999 Kia ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
V6 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil * Disconnect the spark plug wires from the ignition coil * Remove the ignition coil mounting bolts and remove the coil from the valve cover V8 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil if youre going to remove more then one ignition coil mark each electrical connector with its corresponding coil to prevent mix-ups during reassembly * Remove the ignition coil hold-down bolt * Grasp the ignition coil firmly and pull it straight up
* Disconnect the negative battery cable * Disconnect the ignition coil electrical connector * Remove the the coil mounting screws and pull the coil up with a twisting motion
You can remove the 1999 Cadillac Deville ignition switch by removing the retaining ring. The retaining ring will be at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the back of the switch. Reverse the process to install the new switch.
Positive to battery or fuse, light to dimmer switch (if used) Negative to negative on cars ignition coil.
change the Ignition Lock lock switch
http://forums.maxima.org/4th-generation-maxima-1995-1999/146706-how-do-i-change-ignition-switch.html
my relay switch is broken and has gotten my transmission in over drive-did you find the switch?
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.
please give instructions on replacing the ignition switch on my 99 Malibu
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
A 1999 Honda Civic Ignition switch is located under the steering column. Remove the steering column. The switch is seen connecting to the dash harness and lock cylinder. Unplug the switch from both places and replace with a new unit.
If you haven't been trained to work on an air-bag, you take the vehicle to someone who has been. This guy has no idea what he's talking about . The ignition switch on this car is in the dash, not the column. If it was in the column, he'd be right, but he's not.
On the colum strait across from the key lock.
The timing belt on a 1999 Kia Sephia is changed by removing the timing cover, loosening the tensioner, and pulling the belt off. A new belt is then put in place and then tension reapplied.