Hey Melissa==The ignition switch is mounted on the top of the steering column, under the dash about 18 inches from the floor. Just remove the 2 screws that hold it on and pull it off. GoodluckJoe
----------------------
There are 2 parts to the ignition switch...The cylinder with the key and the electrical ignition switch mounted on the top of the steering column as Joe (first answer)pointed out. The 2 components are connected by a steel rod.
However the ignition switch on the top of the steering column is a bit trickier to change than Joe noted. To get access you will need to drop the Steering column down.You will need to pull the dimmer switch first to get to the ignition switch. There is a rod the actuates the dimmer switch. You must be careful to get it back in correctly. Also you will need to adjust the ignition switch as it is slotted. As is the dimmer switch...it is also adjustable and you will need to get it adjusted correctly.
Also be extremely cautious if you have a column shift there will be a clip for the PRNDL needle in your dash that will break if you dont disconnect it first. Make sure you mark its position first.
Replace ignition switch for 1993 buick century?
do I remove steering wheel to change out ignition
Where is the backup light switch on a 2002 buick century?
Ignition what? Switch? Coil?
how to replace window toggle switch 1999 buick century
The ignition switch. Where the key goes in is the key tumbler.
How do you Change a fuel pump on a 1985 Buick Century?
I have the same problem with my 1989.The best I have found so far is this:How_do_you_change_an_ignition_Switch_on_a_90_Buick_Century
The 2001 Buick Century brake light switch is located beneath the dashboard, on the drivers side. The brake light switch should be labeled as such.
There is no such thing as a 2005 Buick Century
http://www.automotivehelper.com/topic1054152.htm or Goole "ignition switch replacement 2001 regal"
The 1996 Buick Century horn relay switch is located behind the dashboard. The relay switch will be on the drivers side of the dashboard.
$27.50 as of Mar.17,2014
Under the hood beside the battery.
89 Buick Century uses a timing Chain. Not a belt.
Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
The steering column in a Buick Century covers the steering shaft and houses the turn signal switch. Some Century cars have a tilt column as well.
turn ignition on leave it on for 10 minutes then switch ignition off then you start the car
how do you replace a ignitionswitch tumbler 1991 buick skylark
On top of the lower portion on the steering column.
There is none on GM vehicles.
I had the same problem with my 98 buick regal gs and it turned out to be the ignition switch.
yes u can all u need to do is go to a car store and buy the parts that you need for the ignition switch and put it in and it shud work i am a son of a machanic.
It could be the ignition switch or a fuse. Maybe a relay.
First you have to remove the steering wheel, that's why I would leave it to a pro. There's a Haynes manual (#38025 (1420) that has the complete instructions for removing the steering wheel and ignition switch. Try Amazon or Ebay to find one. They're dirt cheap now.