0
The switch is on the steering column about 18 inches up from the floor. There are 2 screws that hold it on,
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you change the ignition switch on a 1992 g20 Chevy van?
Begin by removing the retaining ring at the top of your 1992 Chevy ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
How do you remove ignition switch from 1992 Ford Explorer?
Type your answer here... How do you remove ignition switch from 1992 ford explorer?
Where is the ignition switch located on a 1992 VW?
the ignition switch is the key and its on the stering collem or on the dash
What is the ignition timing spec for a 1992 Chevy Camaro with 305?
6 BTDC
Replacing a ignition switch in the dashboard of a 1995 4- Runner?
pics of 1992 4runner ignition switch
How Do You Replace Ignition In 1992 Cavalier?
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
How do you replace the ignition switch on a '92 Plymouth Colt?
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
How many quarts of oil is needed for a 1992 Camaro?
The 1992 Camaro takes 4.0 qts without filter change
How do you replace ignition switch on a 1992 Pontiac Bonneville?
How do you replace the ignition swith opn a 1992 Pontiac Bonneville se
Where is the Inertia switch in a 1992 Camaro RS?
Gm does not use inertia switches.
How do you change the ignition switch on a 1992 Plymouth acclaim?
on my '91 with tilt steering the ignition switch is located underneath the key, inside the steering column only three screws hold it on, but alotta torx hold that cover on.....have fun
How do you change the ignition switch on a 1992 Fifth Ave?
You have screws on the underside of the steering column take those out with a star screwdriver take the cover off. Now take the screws out of the switch and you might have to have a key to turn the ignition, the switch comes right out with the wires on. Hope this helps
