0
How do you change the knock sensor on a 2003 Chevy Silverado 1500hd 6.0?
Wiki User
∙ 14y ago
You probably mean the NOX sensor, it is the exhaust in front of the converter and the V8 has at least two of these sensors, easy to get to after you get under the truck, just unplug the wire and remove from the exhaust
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change the knock sensor in a 2003 Chevy Silverado 5.3?
how do you change the knock sensor in a 2003 Chevy silverado 5.3
What is the correct tire pressure on a 2005 Chevy silverado 1500hd?
35psi
Where is a 2003 Chevy silverado 1500hd 6.0 throttle position sensor located?
Front of throttle body. All one piece, and wiring plugs in on passenger side
What is the fuel pressure on an 02 Chevy silverado 6.0 liter?
what is the fuel psi running on a Chevy 2002 1500hd with the 6.0
What size speakers fit front door of 2002 Chevy 1500hd silverado?
6.5" round speakers.
How do you change speed sensor on Chevy Silverado?
The speed sensor on a Chevy Silverado is located on the tailshaft of the transmission. To remove it, unplug the wire hardness, unscrew the bolt holding it in place, and pull it out.
What block size is in the 2002 Chevy silverado 1500hd 6.0L?
That is a V-8 engine: 6.0L has 364 cubic inches.
Stock rear end gear ratio in a 2001 Chevy silverado 1500hd?
3:73 with 4:10 as option
Where is the camshaft sensor on a 2000 Chevy Silverado?
were is the cam shaft sensor
Where is the coolant sensor on a 95 Chevy silverado located?
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
Does a Chevy 1994 silverado 1500 have an IAT sensor?
NO it does not.
How do you replace oil pressure sensor for 2005 Chevy silverado truck?
The process to change the pressure sensor is the same for any engine in the 2005 Silverado, but the location may change between engine types. The sensor should be close to the oil filter. Remove the sensor wire, then screw the sensor out. Screw a new sensor in, then reconnect the wire.
