As i am doing it now. remove the two Philips head screws that hold the back-up light housing in place, use a flat head screw driver to pry them from the body. They are also held in place by a couple of clips. The center bulb is your guy. Twist the plastic holder to the left a bit and pull out the bulb holder. The bulb then easily pulls out. I took this down to Napa and for just a couple bucks they grabbed me two more. If after changing the bulbs they still don't illuminate and neither do the lights on your gear shift collum ie: P-R-N-D-2-1 then you have a much bigger problem like i am dealing with
good luck!
Phillips screwdriver...two screws throught the lens. Remove the lens and extract the lamp. It pulls out.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
how do u change the license plate light on a 2005 sienna
Check your maintenance manual. It's in there.
have you tried pulling the EFI fuse
There's a Phillips screw at the top of the marker light. You would need to unscrew that and then you will be able to remove the side marker light from your Toyota 4Runner. We have also included a link to a video in the related links section below.
Type your answer here... Hello how do you reset the check engine light on a 2003 Toyota 4runner. Thanks
The 2001 Toyota Camry license plate light fuse can be found in the fuse box. The license plate fuse will be labeled as the tail light fuse.
I just did this on my 4-runner and took pictures. Check out my web sight and see if it helps you. http://www.95zuk.com/tail_lights/
Turn the 4Runner on, make sure that you are looking at the "odometer" miles and not the "Trip" miles. Turn the 4Runner off, hold the "reset" button, turn the 4Runner On and the "MAINT" light will blink 3 times. Release the "reset" button and the light will turn off. This worked great for me but the light flashed 5 times then went off. 2007 SR5 4WD 16,000 miles recently purchased from dealer hopefully there is nothing else wrong/ FYI the manual told me that the maint light is for oil change.
Changing a rear license plate light on a 1991 Toyota Corolla will be very easy to do. You need to take the license plate off and then unscrew all the plastic screws holding the light cover in place. After the screws are out, remove the cover and unscrew the old bulb and replace it with a new one.
open the trunk and take off the cover and just do it