answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2015-07-15 19:55:33

To replace lock cylinder in the hatch ,first inside hatch panel must be removed.

After removing the panel you will have access to the lock cylinder. Remove the linkage to

the cylinder and pull the retaining clip from the cylinder and the lock can be removed

from the outside of the latch. This is not a hard job to do , 1 hour max if your slow .

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

How do you change the timing belt on 1998 Chrysler town and country?

A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.


Where is the cabin air filter on a 1998 Chrysler Town and Country?

A 1998 Chrysler Town and Country does not have a cabin filter.


How do you change the clock on 1998 Chrysler fifth avenue?

There is no such thing as a 1998 Chrysler Fifth Avenue


How do you change the clock time on Chrysler fifth avenue 1998?

There is no such thing as a 1998 Chrysler Fifth Avenue


What type of brake fluid should be used for a 1998 Chrysler town and country?

A 1998 Chrysler Town and Country uses DOT 3 brake fluid.


Where does the spare tire go on a 1998 Chrysler town and country?

The spare tire on a 1998 Chrysler Town and Country is mounted under the very rear of the van.


Where does the Wiper switch on a 1998 Chrysler Town and Country get power?

The wiper switch on a 1998 Chrysler Town and Country gets power from and is an input to the body computer.


How do you remove the evaporator on a 1998 Chrysler town and country?

97 Chrysler town & country evaporator bolts location for removal


How do you fix starter on a 1998 Chrysler Town and country?

Replace it.


Will a 1994 3.8 Chrysler Town and Country Transmission work in a 1998 3.8 Chrysler Town and Country?

No, all of the sensor plugs are different.


How much transmission fluid is used in a 1998 Chrysler town and country?

Filter change, about 5 quarts Dry fill, about 9 quarts.


What is the spark plug gap for a 1998 Chrysler Town and Country?

.050 in.


How do you change the dim headlight bulb on a 1998 Chrysler Town and Country?

You have to remove the headligth assembly. There are 3 nuts on the back, and 1 bolt on top.


How do you change the alternator on a 1998 Chrysler Concorde?

To change the alternator on a 1998 Chrysler Concorde, disconnect the negative terminal of the battery. Then loosen the two bolts that hold the alternator in place. Pull out the alternator and replace.


How do you reset garage door opener on 1998 town and country?

on a 1998 Chrysler Town and Country how do you reset the On board garage door opener


When to change the timing belt in a 1998 Chrysler Sebring LXI?

Change it every 100,000 miles.


Where is the fuel pump located in a 1998 Chrysler Town and Country?

It is in the fuel tank.


What ac freon type in 1998 Chrysler Town and Country?

R-134A


What tires are recommended for a 1998 Chrysler Town and Country?

215-65-16


Where is the starter on a 1998 Chrysler Town and Country?

Front of engine, near radiator.


How do you add brake fluid to a 1998 Chrysler Town and Country?

It is important to keep brake fluid in a car. Brake fluid is added to a 1998 Chrysler Town and Country, under the hood into the reservoir labeled 'brake fluid'.


Will a 1998 3.8 motor inner change with a 2001 chrysler town and country?

No. Too many differences.No. Too many differences.


How do you change spark plugs in a Chrysler 1998 town and country 3.8 liter engine?

I access them from underneath, other people remove the wiper cowl and intake plenum.


How is the cabin air filter replaced on a 1998 Chrysler town and country?

It doesn't have one.


How long does a 1998 Chrysler Town and Country transmission last?

150,000 miles is about average.