answersLogoWhite
Dodge Intrepid

How do you change the motor and heat control from an 1994 Dodge Intrepid?

484950

Top Answer
User Avatar
Wiki User
2011-11-24 00:16:51
2011-11-24 00:16:51

the motor is in the engine compartment on the passenger side firewall and the heat control is inside the car below the radio, just pull the trim piece off and unbolt the control unit and replace it.

1

Related Questions

User Avatar

Will a 2004 Dodge stratus motor fit into a 2003 Dodge intrepid car with a 2.7 engine?

User Avatar

The 1995 Dodge Intrepid has two motor mounts. One on the left and one on the right.

User Avatar

1999 dodge intrepid rear windo don't know working i change 2 time same place you can Email .e sunilpatel2002@hotmail.com

User Avatar

A neon uses a 4 cylinder, an Intrepid uses a 6 cylinder, plus there wasn't a 1990 Intrepid.

User Avatar

It is located on top of the transmission next to where is mounts up with the motor

User Avatar

A 1997 Dodge Intrepid has two engine mounts and one transmission mount.

User Avatar

No, a Stratus engine sits transverse, while the Intrepid sits front to back.

User Avatar

The Dodge Intrepid was always front wheel drive.

User Avatar

With the proper tools and information it is not a hard job.

User Avatar

No. The 1997 computer system is completely different than the 1999 system.

User Avatar

Yes, with the computer, harness, and plumbing from the 3.5L

User Avatar

No, it will not, design is much too different to make it feasable. For a 2000 intrepid you must use a 1998-2001 engine. Check out dodgeintrepid.net for a ton of info on these cars.

User Avatar

yes that is one of the engine options.

User Avatar

As long as they are the same size and all the plumbing and eletrical line up. A 3.3 liter into a 3.3 liter, for example.

User Avatar

No, you need a 2.7, or preferably a 3.2 or 3.5 liter between 1998 to 2004 for this car. It will probably cost more than the car is worth to replace the motor at this point.

User Avatar

The 2004 Dodge Intrepid cooling fan relay switch can be found on the back of the cooling fan motor. The cooling fan relay switch is attached to the fan motor with two retaining screws.

User Avatar

its down under the pass side dash two screws hold it in place and one plug

User Avatar

You have to unbolt the wipers off the car then take off the cowl panel by either bolts or clips then the motor should be exposed then simply unbolt it.

User Avatar

The starter on a 2000 Dodge Intrepid 3.2 L is located on the driver's side of the motor. It is way down low next the fly wheel area.

User Avatar

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528021993f

User Avatar

the middle left of the motor towards the bottom

User Avatar

the middle left on the motor from the front of the car


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.