0
How do you change the motor on your windshield wipers on a ford expedition?
Wiki User
∙ 15y ago
Windshield Wiper Motor Removal & Installation Front 1. Turn the ignition switch to the ON position. Turn the ignition switch ON until the wiper blades are straight up, then turn the ignition switch OFF. 2. Disconnect the negative battery cable. 3. Remove the right-hand and left-hand windshield wiper arm and blade assemblies. 4. Remove the cowl top vent panels. 5. Detach the electrical hardness connector at the windshield wiper motor assembly. 6. Remove 3 wiper motor (module assembly) retaining bolts and remove the module assembly from the vehicle. 7. Remove the wiper linkage retaining bolt and remove the linkage from the wiper motor. 8. Remove 3 retaining nuts and remove the windshield wiper motor. To install; 9. Place the windshield wiper motor in position and install 3 retaining nuts. Tighten to 10-12 ft. lbs. (12-17 Nm). 10. Connect the wiper linkage to the windshield wiper motor and install the retaining bolt. Tighten the bolts to 14 ft. lbs. (20 Nm). 11. Place the wiper motor (module assembly) in position and install 3 retaining bolts. Tighten the bolts to 6 ft. lbs. (9Nm). 12. Install the electrical hardness connector to the windshield wiper motor. 13. Connect the negative battery cable. 14. Allow the windshield wiper motor to cycle several times while checking for proper wiper motor operation. 15. Turn the windshield wiper motor to the OFFposition to park the wiper motor in the park position. 16. Install the cowl top vent panels. 17. Install the wiper arm and blade assemblies. Install the retaining nuts and tighten to 22-29 ft. lbs. (30-40 Nm). 18. Connect the negative battery cable. Check the windshield wiper motor for proper operation and the wiper arms for adjustment.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why Windshield wipers not working but you can hear the motor running?
If the motor is turning, but the wipers are not moving, then you have a broken or disconnected linkage.
Windsheild wipers skipping on low 2002 trailblazer?
The 2002 Chevrolet trailblazer windshield wiper motor should be replaced, when the windshield wipers are skipping. The windshield wiper motor can be located in the engine compartment.
What could be wrong with a 1991 jeep Cherokee if just the windshield wipers went out?
MOTOR FOR WIPERS
What causes Windshield wipers to move slow?
Binding in the linkage, bad windshield washer motor
Why won't the windshield wipers turn off?
If the windshield wipers do not turn off in the vehicle, there could be a short between the battery and the wiper motor. It is also possible that the motor is malfunctioning due to the motor not being properly grounded.
How do i prevent windshield wipers from stopping in the middle of the windshield?
ughh i have the same problem. you need to fix the windshield wiper motor
What causes slow windshield wipers on a 1994 Jeep Cherokee I replaced the wiper motor but there was no change.?
Weak battery or alternator output.
Intermittent windshield wipers were introduced by whom?
Ford Motor Company
In a 1991 Toyota Camry does the wiper motor operate both the windshield wipers and the windshield washer fluid?
no
What causes windshield wipers to stop working?
Windshield wipers are an important safety feature on cars. They stop working when their motor goes out, or when the blade is too worn out.
I have replaced the windshield wiper motor and the washer pump and my wipers still don't work how do i fix the windshield wipers on my 1969 Chevrolet Camaro?
check the fuses and relays
How do you get to the windshield wiper motor on a Mk4 1999 volkswagen jetta?
It is under the cowl thing. You must remove the wipers. MAKE SURE YOU MARK THE LOCATION OF THE WIPERS ON THE WINDSHIELD.
