It is really about the belt, but I hope ie helps, Deere has many sites and navigation can be difficult.
300xloadersticing
Most commonly there is a red cable and a black cable that conect to the battery. The red cable is the positive one. If the cables on your lawn tractor are color-coded, then the cable that connects to the battery post marked with a (+) is the positive.
1. Locate the tractor battery cables. 2. Follow each cable to where it connects to the tractor. One cable will be connected/attached to the tractor chassis/frame. The other cable will be connected/attached to the tractor starter motor. If you don't find this to be true, then discontinue this procedure now. 3. Connect the unconnected end of the cable that is connected to the starter motor to the "+" or "pos" battery post. 4. Connect the unconnected end of the other cable that is connected to the tractor chassis/frame to the "-" or "neg" battery post. 5. Snugly tighten the post connector nuts to ensure a firm/stable electrical connection. Done. Your battery is now connected to your tractor properly.
the clutch cable attaches to the small pulley on left front of tractor mowing deck . there is a flat washer first than the cable than a locking pin to hold it hope this helps
You will need a voltmeter. Hook the red cable to the + post and the black cable to the - post and it will show the voltage.
how 2 change a 1999 speedo cable
how do you change clutch cable on cobalt
because it is very smooth wire when we use hollow cable then cable crack to automatically and not connect toconnector's and may be if use to hollow conductor in1/2" flex radio feeder cable then result change
how do you change the handbrake cable on a 1997 Toyota rav4
How do you change the choke cable on a 2000 Honda Rancher?
You can buy the part online or at your local John Deere dealer ~$30. Take the hood off, remove the battery, and from the bottom side you should be able to access the two bolts. You will need to remove them as well as the screw that holds the cable on at the engine. You can replace just the lever, but it comes complete so you might as well do it all. The bolts are a real pain. You will need extensions and a universal joint. Bolts should be 10mm. Be careful not to strip the threads.
To change the speedometer cable on a 1990 Toyota truck, disconnect the cable, feeding it through the grommet, then disconnect it from the transmission. The process can then be reversed with the new cable.