# Disconnect and isolate the battery negative cable. # If the vehicle is so equipped, remove the tilt steering column lever. # Remove both the upper and lower shrouds from the steering column # Remove the lower fixed column shroud. # Move the upper fixed column shroud far enough to access the rear of the multi-function switch # Remove the tamper proof mounting screws (a Snap On tamper proof torx bit TTXR20B2 or equivalent is required) that secure the multi-function switch to the steering column. # Gently pull the switch away from the steering column far enough to access and remove the multi-function switch wire harness connector screw. # Unplug the wire harness connector from the multi-function switch. # Reverse the removal procedures to install. Tighten the fasteners as follows: #* Multi-function switch wire harness connector screw - 2 N·m (17 in. lbs.) #* Multi-function switch mounting screws - 2 N·m (17 in. lbs.)
It is the turn signal/wiper switch
The answer depends on what equipment has your multi-function display. I suggest you refer to the user manual.
"Multi-function switch" usually refers to the turn signal/wiper control module which is located on the steering column at the base of the signal/wiper control lever.
You can change a bulb in the multi function display unit of a 307 by first making sure that the lamp is turned off. Then unscrew the bulb and remove it from the lamp.
YesYes
P0585 is Cruise Control Multi-Function Input A/B Correlation
Lick it then shove it right in (no mercy)
The trace route command is used to ping a multi-function device.
Trouble code P0591 means: Cruise control system multi-function input B - circuit range/performance problem
No, multi point fuel injection.No, multi point fuel injection.
TARUB
what is the function of the switch ? and what does it do ?