0
# The sensor is located in the exhaust manifold or exhaust pipe and is accessible from under the vehicle # Since the oxygen sensor may be difficult to remove with the engine cold begin by operating the engine until it has warmed to atleast 120 degrees # Disconnect the electrical wire from the oxygen sensor and carefully unscrew the oxygen sensor from the exhaust pipe.Be adviced that excessive force may damage the threads inspect the oxygen sensor for damage unless you are replacing it
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the Cam Sensor on a 1999 Jeep Cherokee?
It is inside the distributor.
O2 sensor relay location on 1996 Jeep Cherokee 4.0?
location of relay for heated o2 sensor 1999 jeep Cherokee sport
How do you change a throttle position sensor on a 1998 Jeep Grand Cherokee?
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
Where is the throttle positioning sensor on a 1999 Jeep Cherokee?
The throttle position sensor is mounted on the side of the throttle body
Where is the battery temp sensor on a 1999 jeep grand Cherokee?
On my 1999 Jeep Wrangler the batt. temp sensor is underneath the battery and mounted to the batt. base plate through a hole in the plate.
Where is tps sensor located on a 1999 jeep Cherokee?
It is on the throttle body opposite of where the cables hook on.
Where is the fuel tank ballast resistor in a 1999 Jeep Cherokee?
There is no such part on a 1999 Jeep Cherokee.
Do you have to take the ball joint loose to change the axle on a 1999 jeep grand cherokee?
No.
What does perform service mean on a 1999 Jeep Grand Cherokee?
Time for an oil change.
Where is the 1999 jeep grand Cherokee ac drain?
where is the ac drain on 1999 jeep grand cherokee limited
Where is the air flow sensor for 1995 Jeep Cherokee?
There is no afs on a cherokee, they run on a map sensor.
Where is the MAF sensor on a 1998 Jeep Cherokee?
A 1998 Jeep Cherokee does not have a mass airflow sensor. It uses a manifold pressure sensor, MAP, which is on the rear of the intake manifold.
