If you go to managemylife.com and enter your model number,385.17824090, it should take you to a page where you can download the manual for your machine. It should tell you how to change your presser foot.
The belt of a Sears Kenmore Sewing Machine may break. You can replace the old belt with a new one.
I would need to have more information on the vehicle as to the year, make and model.......
it depends if you have a ball joint presser. i would say about an hour
Kenmore eliteelectric dryer model # 110600729990 says its drying, nothing happens
Remove the two screw covers on the housing surrounding the needle piston mechanism (on the left end and upper back of the machine), unscrew the screws then wiggle the housing free. The light bulb is in a grey rubber "socket" grab the bulb and pull it out.
Its located on the left side of the motor, be careful when you disconnect the fuel lines, there is a lot of presser, very basic
Its located on the left side of the motor, be careful when you disconnect the fuel lines, there is a lot of presser, very basic
It has sensors to know what you put in the machine and a calculator to give change to you in coins.
A compound machine is a machine that is made up of more than one simple machine. They they change the amount of force and the direction.
there is a thermostat in the back of the machine that janitors can change
No.
If it comes with directions, follow those directions. If not just call sears.