Radiator hoses are quite simple to change. The Upper hose is located under the hood, It exits the right hand side of the motor as your looking at it from outside, and runs to the far right corner of the radiator. it is held on by two clamps. Remove the clamps and replace the hose. The Lower hose is located on the left side of the motor, under the air conditioning compressor. It mounts to the engine block itself, then runs to the left over to the Radiator. It is also held on by two clamps. Remove these clamps and remove the hose. Remember, Do not open the coolant system while the coolant is HOT... you can burn youself.
To replace a radiator on a 1991 Thunderbird Super Coupe, a person has to drain the old radiator, then unhook all of the hoses. The radiator is bolted to the cross beam in the front and held in by bolts and screws along the sides and bottom. It is a good idea to take a picture of the old radiator and hoses to use as a reference when installing the new one.
Yes! both the radiator and the hoses are swapable :) Just besure that if your vehicle has a automatic transmission the radiator has the automatic transmission cooling line fittings.
Changing a radiator in a 1997 Pontiac Grand Am can be a difficult task. To remove the radiator, all of the radiator hoses will need to be disconnected from the radiator. The transmission lines will also need to be removed. After all of the hoses are disconnected, remove all of the clips that are holding the radiator in place. Lift the radiator up and place with a new one. All the hoses and clips will need to be put back in place with the new radiator.
peice of cake man,especially being manual,remove the fan that is held on with one ten mm bolt than the hoses and pull her out of there.
Drain the coolant from your Ford Fiesta radiator. Remove the radiator hoses. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install your new radiator.
check your radiator hoses and change gaskets
Drain the water from your radiator. Remove the top and bottom radiator hoses. Remove the radiator stabilizing bolts. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
Open the hood remove the shroud then unhook the transmission lines and radiator hoses then lift out the unit.
There is no strict rules about that. You need to inspect hoses periodically. But when you have a car which is 10 years old you might need to change all vacuum hoses around the engine.
Before changing the radiator on a 2001 Pontiac Montana the coolant must first be drained. After the drain remove the radiator mounts, fans, and hoses. Pull the radiator upwards.
Drain the water from your 1972 Chevy Corvette radiator. Remove the radiator hoses. Remove the stabilizing arm retaining bolt. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
Your radiator might have a small pinhole in it, causing it to not build up pressure.