open the trunk, you should see clips or screws holdig your upholstery on remove these clips or screws and then you can remove the panels and you will see the main structure of the car and there will be access holes big enough to put your hand through and reach the bulbs, hope this will help you. on caprice 2 and 4 door sedans open trunk and look at area behind loghts you will see large black plastic cap nuts remove them and the entire rear pannel that holds the lights will then be able to be removed. turn the bulb sockets counter clockwise and they will come ou. replace the bulbs and reverse to put back together. on caprice wagon use a torx screwdriver and remove the 4 screws that hold the light fixture to the body then replace the bulbs and reverse to replace
check all brake bulbs a filiment may have shorted out
with the new one ! THE i said THE NEW ONE not A NEW ONE , THE .
How_do_you_change_the_fog_lamp_bulbs_on_2002_Chevy_Impala
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
Replace the turn signal flasher. I think on that model it is under the dash on or near the column.
how do I replace interior light bulbs in 2002 chevy impala. I removed the cover, but the bulb is cramped in and I can't pull it out.
pull up on the turn signal lever,check the bright lights relay,check the bulbs & wiring. etc,etc,etc
To replace the headlight assembly on the 90 Caprice, you may need to remove the grille. You will need a quality Torx(r) screwdriver. Once the headlight assembly is out of the vehicle, the bulbs can be removed. The bulbs turn about 75 degrees counter clockwise. If the vehicle has Halogen bulbs, be careful not to touch the glass tubes with your bare fingers as the oils from your fingers can cause the bulbs to fail.
twist and pull out
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
If you can't access the bulbs take the light assy off and turn the bulbs counterclockwise to remove them
there is two rods that go through the housing from the top. turn them to unlock and pull up and out then the whole assembly comes out and you can change the bulbs.