To change a taillight bulb, first, open the rear hatch. Look inside at the edge where the taillight is. You'll see 2 black round tabs (snap-in button)near the taillight. Take a screwdriver and pry each one out far enough so you can pull them out with your fingers or pliers. You may have to turn or wiggle them but they'll come out. Those are what hold the taillight housing on.
Pull the housing off and look at the back. You'll see the plug in the middle, and 2 round covers with tabs, or "ears" on them. There is one bulb under each of the covers. Determine which bulb you need to change, then squeeze the ears in and pull the cover you need off. The bulb is attached under it. Just pull the bulb out, push the new one in, then push the bulb housing in by squeezing the ears again. You'll hear it snap in.
Then put the light housing back on the van. (The tab in the front goes into the slot, and the holes should line up for you to push the tabs back in to hold the housing. You can just push two snap-in buttons back in with a pushing of your fingers without any problems.
That's it, your done! easy cake! It should take under five minutes for the whole process. Save your buck from paying to dealer
-Rick Riordan. & Rich Robinson
Give me food and I will live give me water and I will die what am I?
What is 8 divided by 2(2 plus 2)?
A teacher walks into the Classroom and says If only Yesterday was Tomorrow Today would have been a Saturday Which Day did the Teacher make this Statement?
What is pokediger1s password on roblox?
Who was Hillary Clintons running mate in the 2008 presidential elections?
Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.